Tractor Talk Discussion Board |
Re: exterior HYD lines
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on October 02, 2005 at 09:30:03 from (64.21.249.40):
In Reply to: exterior HYD lines posted by Just Bill on October 02, 2005 at 01:04:52:
You can get a low GPM source (a little over 1 GPM) by chaining down the 3-point, and then tapping into the hydraulic test port on the pump. Others have given the fitting size. You then tap a hole into the axle side-cover for the return. Or, you can get a 12 GPM pump, and a drive kit to drive it off the engine's front crankshaft pulley. This site (YT) sells the drives and the pump.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Central Illinois Strawberry Festival - by Cindy Ladage and Janna Seiz. Every year the coming of summer is highlighted by different events for different people. For some, it is heralded with the end of school, tilling the garden, or completion of the planting season. To us, connoisseurs of find food, antique tractors, farm toys, crafts, and downright fun, the annual Strawberry Festival means summer is here. Every year, in Carlinville, Illinois, the Macoupin County Historical Society and the Macoupin Agricultural Antique Association team up to fill th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|