Tractor Talk Discussion Board |
Re: plugging in the diesel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John S-B on October 05, 2005 at 20:03:16 from (69.223.142.17):
In Reply to: plugging in the diesel posted by Rich Iowa on October 05, 2005 at 19:45:27:
I start plugging mine in when it gets below 50 or so. I'm on a volunteer fire dept. where I live so sometimes I gotta go, can't take time to warm it up. The block heater is not going to keep it at operating temp, but it will sure cut down on warm up time and with fuel prices every bit you save will be worth it. I think it only costs pennies to plug it in and saves on fuel and engine wear.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|