Tractor Talk Discussion Board |
Re: Hand warmer for JD 4010
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by R. John Johnson on October 08, 2005 at 06:39:56 from (205.200.43.207):
In Reply to: Hand warmer for JD 4010 posted by broker farmer on October 07, 2005 at 06:46:34:
I put heat in our 4010 a few years ago. Many years ago the water pump went and the dealership broke the casting rebuilding it. The replacement pump had a port on the top. I beleive it was originally for a early model 4020. I removed the plug from the port and installed a barbed fitting. I installed a Tee in the heater hose running to the tank type block heater(Yes, I live in Canada. )The heater was originally intended for use is a skid steer loader and simply re-circulates air in the cab rather than heating fresh air coming in. I installed a ball valve between the tee and the heater. Everything was plumbed with 5/8 heater hose. You need to be plumbed into the water pump to provide positve flow through the lines. This is how ALL heaters using engine coolant as a heat source, work. The ball valve acts as temperature control by controling the flow of hot engine coolant to the heater. The heater had its own built in fan. One word of advise. The cab on our 4010 is full of holes and lets in a lot of air on a windy day and the effectiveness of the heater drops off quickly. Trying to keep your hands warm by blowing hot air on them might not work very well. I agree with the other posters who said get a cab or a heat houser. You will be much more comfortable and happier. My two cents. John
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|