Tractor Talk Discussion Board |
Re: Binders while chaining up.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 720Deere on October 09, 2005 at 13:43:35 from (70.22.45.142):
In Reply to: Re: Binders while chaining up. posted by New-Gen on October 09, 2005 at 05:33:46:
"Ok.....now....(still with me?)....let"s put a chain and binder on each corner, pullng crossways....(you know...like the DOT VERY strongly recomends and most intellegent people concerned about public safety and their own liablity would do)...A binder comes loose....now....(at this point you may have to get a calculater or a second grader to help you with the math).....How many binders are left holding the load???? FOUR!!!!! WOW!!!! What a CONCEPT!!!!!!!" If you have four and you take away one, my peabrain tells me (a second grader would probably tell me the same) that you have three left. Three is better than none for sure, but it's not FOUR as you so strongly stated. If you're going to make a strong statement, get it right so the peabrain is the only one that looks stupid.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|