Tractor Talk Discussion Board |
Re: JD 5020 injuction pumr removal
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by New-Gen on October 10, 2005 at 14:55:07 from (4.158.0.23):
In Reply to: JD 5020 injuction pumr removal posted by 37 chief on October 10, 2005 at 14:33:26:
IMHO whenever the pump is removed/reinstalled the seals should be replaced, if for no other reason as a matter of precaution. The extra cost and trouble of doing so while you're at it is minor compared to the consequences of having diesel fuel in the crancase if the old ones should fail. I'm not sure about the 5020, but 4320/4620 have a seal with a lip, on those the trick is to CAREFULLY use a screwdriver to keep the seal from rolling as you work th epump back on the shaft...
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|