Re: JACKING A WD-45

Posted by JMS/MN on October 12, 2005 at 21:41:30 from (204.73.106.15):

In Reply to: JACKING A WD-45 posted by Keith in Iowa on October 12, 2005 at 16:53:51:

Years ago I bought some 5x6 pole shed posts, cut them about 20 inches long. Had to support a 175 hp Case 2470 tractor. Bolt four pieces together, gives you a block of 10. 12. or 20 inch dimensions. BOLT them together, no lag screws. I used 3/8 inch redi-bolt, sunk the heads to give a clean level surface. Turn them three ways, always a good jack support. Better than sticking a stump under a 7 ton tractor. Made four blocks, always being used.

Follow Ups:

• Re: JACKING A WD-45 JMS/MN 21:47:26 10/12/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]