Tractor Talk Discussion Board |
Re: OT: Oversized Oil Filter on Cars
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nolan on October 14, 2005 at 07:15:01 from (167.102.133.164):
In Reply to: OT: Oversized Oil Filter on Cars posted by Vinnie on October 14, 2005 at 04:07:50:
Spend a little time with the Baldwin filter catalog and you'll be able to figure out which filters will fit your vehicle, with the proper or acceptable valving and such. It's not hard to find at least a dozen alternatives. The catalog is on the web btw. There is a mild downside to larger filters. They take longer to fill up, and oil pressure takes longer to build up as a result. This is mostly a problem on the initial fire up after changing the filter. Some fret over it, some don't. I haven't seem solid evidence of a problem with this myself. I equally don't see a problem with running a small filter. If your engine is shedding metal particals so fast the filter blinds from them because of its size, you've got far more serious issues to deal with than a small filter. One nice thing you can do with the catalog is look up all your vehicles and see if perhaps you can switch to a standard filter. I've four different vehicles here at home, all calling for different filters. By researching, I was able to go with just one single filter on all the vehicles, which incidentally wasn't specified for any of them.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|