Tractor Talk Discussion Board |
Re: Will straight pipe hurt motors??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve Crum on October 14, 2005 at 08:46:58 from (4.156.228.173):
In Reply to: Re: Will straight pipe hurt motors?? posted by txgrn on October 14, 2005 at 06:30:28:
When you state a 1 7/8" pipe I'm assuming you are refering to a B or similar sized 2 cylinder tractor. The 'pulsation' you mention is indictive of respectable scavenging as long as the duration of the low pressure side of the pulse is not in the negative side of the pressure wave. Flow tests on my own stock B demonstrated that a 1 7/8" stock sized tube although flowing respectably still maintained a degree of steady back pressure at the exhaust ports, and a oversized 2 1/2" tube tested excessive backflow or reversion at the ports. Both these conditions tend to promote "flow stalling" or lost velocity of the outflow of exhaust gases from the cylinder thus screwing volumetric efficency, driving up engine temperature, and driving down potential power. The best flowing tube I've tested on one of these B sized engines that seems to strike a balance between too much and not enough is 2.0". Quite frankly put, if you cannot get as much of the burn't gases out of the cylinder as possable in the split second it has to do so, the incoming charge of fresh air/fuel cannot be so fast incoming in it's own split second. Picture yourself walking out of an auditorium into a crowded foyer, you can move but not real fast, but if people are moving out thru the foyer in an orderly fashion you move right along. If the foyer is empty, people tend to slow down in their pace. I won't even pull out my notebook on cam timing and overlaps or intake designs. But I have quite a list of customers that wanted their pipes painted black so as not to draw too much attention to them. (pullers are just as secretive as NASCAR in what they do to their machines.)
Follow Ups:
Home
| Forums
Today's Featured Article -
A Belt Pulley? Really Doing Something? - by Chris Pratt. Belt Pulleys! Most of us conjure up a picture of a massive thresher with a wide belt lazily arching to a tractor 35 feet away throwing a cloud of dust, straw and grain, and while nostalgic, not too practical a method of using our tractors. While this may have been the bread and butter of the belt work in the past (since this is what made the money on many farms), the smaller tasks may have been and still can be its real claim to fame. The thresher would bring in the harvest (and income) once a y
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|