Tractor Talk Discussion Board |
Re: Grease seals on camper trailer wheels
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP(MI) on October 19, 2005 at 18:21:13 from (64.25.199.4):
In Reply to: Grease seals on camper trailer wheels posted by RayP(MI) on October 19, 2005 at 17:08:53:
Sorry, no pictures, had to put trailer back together - wife needs it to carry luggage into a rabbit convention in Indianapolis this weekend. Ok, guys, throw out everything you know about wheel bearings - took this thing to my NAPA dealer, and he says that he's never seen anything like it... (And he's a counter man of many years experience!) First of all, the axle shaft is not tapered. When you remove the castellated nut, you find a lock washer, and a flat washer. Then WHOLE bearing assembly slides off the axle. There is a sleeve in the center that bearing rides on... Whole hub, bearing and the sleeve come off as a unit. There appears no way to remove seals and thus the bearing from the hub, or even get inner sleeve out. Grease seals look like they're installed backwards, with lips pointing outward, and a groove which would hold a small coiled spring in the groove. I've seen seals which had similar springs, that were apparently to keep inner lip of seal tight against shaft. These seals have the groove, and the tiny spring on the outside, where they are exposed to the elements, thus rust and corrosion. Hubs have a pressed in Zerk fitting, and can be greased with conventional grease gun. These are not like any conventional wheel bearing ai have seen either - Don't know if it has balls, or rollers or what...
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|