Tractor Talk Discussion Board |
Re: Hooking up a Motorola Alternator
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RodinNS on November 15, 2005 at 17:46:39 from (142.177.93.45):
In Reply to: Re: Hooking up a Motorola Alternator posted by JackT on November 15, 2005 at 13:17:08:
Hi Jack, I should have looked at the wiring diagrams first. I think you're right about that stator terminal. It will probably just sit unused. Now, as these Motorola's were used on Ford tractors, the alt was not internally regulated. The alt had a field terminal, as well as an output, Reg, and ground terminal. In this setup, there was a wire from the reg to the field, from the reg to the alternator ground terminal, and another wire from the reg, in parallel with a wire from the key through the charge indicator light, that went to the alternator Reg terminal. So, at a guess, I would say that you need to wire an idiot light into that circuit. Basically, run a wire from the key to the regulator, and then "T" the indicator light into this wire, with the other end of the indicator light wire going to the "REG" terminal on the alternator. Again, this is simply how the tractors were wired, and I'm describing the wiring diagram as best I can. Your situation may be different, but I would suspect that there would need to be some form of indicator light, and that this would provide the initial "excitement" through this wire. Otherwise, I would expect that this alt may have some problems..... In that case I would just go to the local auto parts store and get a reman Delco 10si. They're available in a range up to about 100 amps, and easy to wire. Anyhow, good luck, and if you need more info shout back. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Black Tire Paint - by Staff. I have been fortunate in that two of my tractors have had rear tires that were in great shape when I bought the tractor. My model "H" even had the old style fronts with plenty of tread. My "L" fronts were mismatched Sears Guardsman snow tires, which I promptly tossed. Well, although these tires were in good shape as far as tread was concerned, they looked real sad. All were flat, but new tubes fixed that. In addition to years and years of scuffing and fading, they had paint splattered on
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|