Tractor Talk Discussion Board |
Re: ? about batteries losing charge
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark - IN. on November 21, 2005 at 19:33:14 from (205.188.117.6):
In Reply to: Re: ? about batteries losing charge posted by Alvin NE Wi on November 21, 2005 at 05:23:26:
Well Alvin, you've got me there. Don't know anything about any of the new Masseys. German, right? Have you tried posting over at the Massey board? Anyway, the posts that I've read here seem pretty sound. Seems as though are going to have to start disconnecting until you hit the source that stops the drain. I particularly like the light bulb between the positive terminal and the battery cable - down and dirty, very effective, and cheap. I like that. You probably have lights, I'm guessing. Ever look at it in the dark? Dimly lit dash? Dimly lit lights? Wouldn't be the first time it's happened. You're probably right on electronics unknown to mankind. Maybe chips and stuff none of mine have. See if you can sectionalize it. Break down in large sections. Do the lightbulb trick, then disconnect the positive to the charging circuit (alternator), bulb still lit? Disconnect the positive to the ignition switch, bulb still lit? Things like that. If at anytime the bulb goes out, you have to figure out what's fed off of that leg, reconnect the bulb, then pull them one by one until the bulb goes out again. Electrical problems can cause you to pull your hair out. Just the way it goes. Could be something as simple as a bad ground where the positive seeks ground, doesn't have a good ground, then takes the route through something like dash lights (dimly lit bulbs when should be off). I ran into that once years back - drained the batteries slowly. Good luck, Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|