Tractor Talk Discussion Board |
Re: Once apon a time
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by markloff on December 01, 2005 at 16:42:22 from (204.221.56.156):
In Reply to: Re: Once apon a time posted by Hoosier Pete on December 01, 2005 at 14:36:40:
Alcohol engines take NO more fuel to make the H.P. of a gas engine! Do not confuse a fire breathing METHANOL race engine with an ETHANOL engine. If you built an engine for ethanol use with 12/14 to 1 compression it would get the same economy as a gas engine with 8/9 to 1 compression. Know anyone with a flex fuel engine in their car? You can get 85-90 of the economy on E-85 that you get running gas. The reason you don't get the full ecomony on E-85 (85% ethanol) is because the compression is held lower in order to be able to operate on pump gas. The only thing that's changed when switching between gas and E-85 is the fuel delivery and spark timing. I agree that lugging a high compression alcohol motor down to the last revoluion like they do in tractor pulls will cause pre-ignition but this is not real world use anyways. I also think that the reason high RPM race motors on alcohol don't like to lug down is because they were designed as high RPM race motors?!? Don't compare apples to oranges Mark
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|