Tractor Talk Discussion Board |
Re: Emglo Air compressor puzzle
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by doogdoog on December 05, 2005 at 13:01:00 from (24.161.156.75):
In Reply to: Re: Emglo Air compressor puzzle posted by Jesse in WI on December 05, 2005 at 05:20:37:
Aloha, Are you using the Craftsman only as a receiver tank and it is not running? Ok, how are you running the output of the slave compressor to the Craftsman? If you are running the output of the slave compressor to the Craftsman receiver tank without any check valve in line, then it will leak from the slave compressor when it stops. Does the unloader valve from the slave compressor leak when the compressor is pumping? If it doesn't, then the unloader valve is working correctly. I don't know exactly at what rpm the unloader valve should close but most compressor pump turn faster than 900rpm. Where on the Craftsman tank is the air leaking from? You could have multiple problems so work it one at a time. 1. When slave compressor is running, air should not be leaking from Craftsman tank (see #4). 2. Air should not be leaking from slave compressor unloader valve when compressor is running. If it is then the compressor is turning extremely slow for the centrifugal weights in the unloader to function. It could be stuck if it leaks all the time. 3. No check valve in output line from slave compressor. Put one in. 4. Craftsman tank should not be leaking unless it is purging from the safety valve (excessive pressure in tank for predetermined setting of safety valve). Reason being that the slave compressor has no way of telling when to cut off. That should be enough for now and get back if you have any further questions. Are you able to post a picture of your setup?? Mahalo, doogdoog
Replies:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|