Tractor Talk Discussion Board |
Re: Cold weather starting with glow plugs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SMR on December 08, 2005 at 12:49:54 from (64.187.69.174):
In Reply to: Cold weather starting with glow plugs posted by Bill C on December 02, 2004 at 19:40:42:
I work at a Case-New Holland dealship and regularly use equiptment in cold weather. 1) Any type of coolant heater, any at all is better than ether or glow plugs. 2) Glow plugs are good on most down to about -10. It was -22 here last night ;) 3) Ether is good, in measured quantity. No more than 2 seconds of ether at a time, per start. In such small quantity it does it's job, and no more. You have to understand what ether, or starting fluid is for. It is used to raise the combustion chambers temperature to assist in the cold weather starting of ANY engine. Most notably diesels. A overdose for any engine of any size regarless of other add ons will result in engine damage. The larger the engine the more people tend to add in one shot as opposed to a injection system that delivers a small quantity over a period of time. With cans the majority of the vapors are drawn into the FIRST drawing cylinder. Thus the damage. A way to avoid this is to spray into the air stream wile cranking, so long as there is no one in the way of a run away machine. Or to spray a supplementary alternate into a air filter. I use brake cleaner (Isopropyl alcohol and Xyelene) to lightly dampen the inner air filter, then spray two or three shots (one second burst) onto the outer air filter. This prevents it from being drawn into the first cylinder. And allows seperate fuel to be used. I just had to start a skid steer that has glow plugs, with ether and brake cleaner. After people screwing around burning up the starter and glow plugs for hours.
Replies:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|