|
Tractor Talk Discussion Board |
Re: Replacing Mechanical Fuel Pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on December 11, 2005 at 10:02:15 from (66.244.90.98):
In Reply to: Replacing Mechanical Fuel Pump posted by Tweeter on December 11, 2005 at 09:27:07:
Tweeter, I dont recall anything particular or special in the ones I changed over the years, it sort of depends on where the cam lobes located as to how much tension n how hard they may be to squeeze into position. On some, but I forget if thats Chevy or Ford???? the plunger pin (that actually moves the fuel pump lever arm) has to get pushed up in its bore to get the pumps lever arm into the right place. If theres any short sections of rubber line attached to the pump I like to replace them when changing out a pump. John T
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
