Tractor Talk Discussion Board |
Re: trying to find Breckwell about using corn
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Coldiron on December 13, 2005 at 16:39:45 from (207.200.116.199):
In Reply to: Re: trying to find Breckwell about using corn posted by Jerry Castleberry on December 13, 2005 at 11:44:40:
Jerry, You might try a visit to the local feed store and pick up a small bag of whole corn and give it a try. You may make a mess of ash that you would have to clean up. I dont see how it could ruin your auger unless it is very small and thin. I have tried corn in my two stoves and it works well in both of them with very little air adjustment. Just keep an eye on your stack temperatures to make sure it isnt overheating and blowing out to much of you money.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|