Tractor Talk Discussion Board |
Re: Multi-Viscosity Oil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Aaron Ford on December 17, 2005 at 09:41:26 from (63.235.133.85):
In Reply to: Re: Multi-Viscosity Oil posted by Lumpy on December 16, 2005 at 08:23:59:
I am redoing an old Massey 65 and so far have found 5 gallons of water in the case, 1 quart of water in each planetary, and another pint in the oil bath air cleaner. This tractor has not been serviced for a few years, but this seems excessive. If the tractor is left outside, I would say 2 years is a bit long. Shift boots, breathers, and vents have a nasty way of collecting water.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|