Tractor Talk Discussion Board |
Re: Any one else use a 2-cyl. design?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Sloroll on December 19, 2005 at 15:12:41 from (69.66.221.164):
In Reply to: Any one else use a 2-cyl. design? posted by in-too-deep on December 19, 2005 at 14:56:17:
The early IH used a two cylinder but they were on the same crank throw so it would fire every other revolution rather than the putput putput of JD they went putt putt putt putt. There were ballance issues with this single throw though. Then McCormick had a prototype that looked like a cross between a D JD and a 15-30 Mc-Deering. It had a big spoked hand start flywheel on the side. There were others too. An early Avery and Rumely I believe were two poppers and others of that era.
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|