|
Tractor Talk Discussion Board |
Re: Help!Cracked block
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IaGary on December 19, 2005 at 15:26:54 from (207.32.0.61):
In Reply to: Re: Help!Cracked block posted by Allan in NE on December 19, 2005 at 15:15:44:
There are two ways to weld cast. Ther is the hot method and also a cold method. On a big object I prefer the cold method. You just do a little at a time and don't get it very hot. With the hot Method you need a oven to heat it, then weld, then bring the temp. down slowly.
Replies:
Home
| Forums
Today's Featured Article -
Using Your Tractor: Creating a Seed Bed - by Chris Pratt. When I bought my first old tractor, I had only one idea in mind. It wasn't the preservation of old iron since at that time, I was unaware that people even did this. It wasn't to show off my restoration skills (though I had tried my hand at a couple of old motorcycles in my teens and if I recall correctly, those old motorcycles were sold in boxes about one quarter finished). It wasn't to relive memories of Grampa, Dad or myself out on the back 40 nursing the Farmall pulling too many b
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
