Tractor Talk Discussion Board |
Re: I understand your question . . .
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jdemaris on December 22, 2005 at 17:22:48 from (66.218.22.87):
In Reply to: Need some ideas on how to hook up an alternator-2 posted by old on December 22, 2005 at 16:58:41:
You didn't say what model alternator, but I'll assume it is a 10SI or a 12SI with a plug on top for a two-prong connector - marked #1 and #2. And I'll assume you know for sure that it has the original volage regulator inside of it. #2 can be hooked to the big output terminal. But - #1 is the exciter wire and it must get some battery current to get the alternator to start charging. Once it does start charging, power is no longer necessary in that circuit. But, if you do not have a switch, and leave it hot all the time, it will drain the battery. And yes - I understand what you said about not having a switch. For your situation, usually the voltage regulator inside the alternator is changed over to the self-exciting type. Then, you don't have to hook any wires to it - as someone else already mentioned. Once that type of regulator is installed, it is usually referred to a "one wire alternator" for obvious reasons. Now, if you refuse to spend any money on adding anything - and want it to work without using magic - you can hook #2 to the big output terminal, leave #1 not hooked to anything, and every time you start the tractor -take a jumper-wire and momentarily put 12 volts to the #1 terminal. It will then charge fine until you get done using the tractor and shut it off. I could mention some other convoluted ways of doing it - but they all require extra parts.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|