Tractor Talk Discussion Board |
Re: Water Well Problems 2
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dwight - VA on December 25, 2005 at 10:46:38 from (65.254.172.90):
In Reply to: Water Well Problems 2 posted by john in la on December 25, 2005 at 06:56:11:
Hi John, I don't understand something. You describe a one pipe system but say the distance from the check valve to the bottom of the pipe is 225 feet. My experience is that the one pipe system is for a shallow well and only good for a well depth of about 25 feet. From 25 feet to about 150 feet you can still use a jet pump but normally would use a two pipe system. In either case you have a foot valve at the end of the pipe down in the well to keep the water from flowing from the pump back into the well. The foot valve is really a check valve. Yours might have gone bad. Losing your prime is like a vapor lock in your truck. After 25 years you might want to consider re-doing the whole pumping system. I recommend going to a submersible system where you don't have to worry as much about losing your pump prime. The only drawback is you have to extend power to the pump at the bottom of the well, usually 240 volts. But, it's still a one line system. Hope you're having a good Christmas in spite of the water problems. Dwight
Replies:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|