Tractor Talk Discussion Board |
Re: Water Well Problems 2
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bus Driver on December 25, 2005 at 16:54:58 from (66.226.36.217):
In Reply to: Water Well Problems 2 posted by john in la on December 25, 2005 at 06:56:11:
Something is missing here. If this well is truly 2" diameter and as deep as you say, then a two pipe system is the only thing that will work with a jet pump. For 2" wells, the pipes are concentric and the space between the inner pipe and the well casing is the second pipe. The jet seals against the casing at the bottom and there is sealing cap at the top where the second pipe to the pump is attached. The seal at the bottom is expandable and the pipe is turned to expand or contract the seal. Better get an expert in this type setup to check yours. Your sketch does not match my description, so I may be wrong. I know of no submersible pump for 2" wells.
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|