Tractor Talk Discussion Board |
Re: GMC Truck Engine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fern(Mi) on January 01, 2006 at 06:11:15 from (64.12.117.7):
In Reply to: GMC Truck Engine posted by 37 chief on December 31, 2005 at 23:20:58:
Tooooo many wrongs here don’t make a right. The following is as I remember it!!!! 54 GMC's used a Buick 6 cyl. engine what was slightly longer (1 ½”) than the Chevy 6 cyl counterpart. Also the GMC's at that time had a pedal start near the accelerator. That pedal bell-cranked on a horizontal shaft adjacent to bolted together engine and block. The Bell housing is definitely different. Even starting in 1956 bell housing were many many-different bell design patterns across the GM lines, each division manufacturing there own engines. The 1954 GMC engine’s motor mount was straight out in front of the engine block. The dump truck engine’s motor mounts are mountings are either side the engine. With a few parts swapped and some welding You should be able to fit it all together. Sounds like a good time to me. Good Luck Fernan
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|