Tractor Talk Discussion Board |
Re: 49 Farmall M 6V regulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob M on January 13, 2006 at 10:23:53 from (69.205.118.76):
In Reply to: 49 Farmall M 6V regulator posted by Burntgate on January 13, 2006 at 08:43:20:
Burntgate - The cutout relay will drop out ONLY when the generator voltage drops lower than battery voltage - ie. at slow idle and when the engine is shut down. Can test by watching the ammeter. From idle slowly increase the RPMs - the ammeter hand should suddenly "snap" from a few amps of discharge to 5 - 10 amps of charge when the cutout pulls in. Conversely when slowing the RPMs down, as they approach idle the ammeter will briefly show a fairly substantial discharge (like 8 - 10 amps) then immediatley swing back to a couple amps discharge when the cutout opens. And at shutdown down the ammeter should indicate exactly 0 after everything stops moving. ---- If the cutout doesn't pull in above idle RPM, the spring tension is too HIGH. And if it remains pulled in at low idle or after shutdown, spring tension is too LOW. If you must adjust the spring tension do it in smallest increments possible. Cutout relay spring adjustment is very sensitive as you will find!!
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|