|
Tractor Talk Discussion Board |
Re: Hydralic help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by J. Schwiebert on January 14, 2006 at 15:05:19 from (209.143.51.246):
In Reply to: Hydralic help posted by todd in ne. on January 14, 2006 at 14:39:34:
Well you did not tell me how fast you are running the engine nor what model of pump you have. I take it it stalls when the wedge hits the wood. What is the tooth count on the engine? on the pump? Also remember it takes 1 horse power for each one gallon of flow at a pressure of 1500 PSI. If it goes really fast your pump has a lot of flow. If nothing else tell me what the bore and stroke of your cylinder is and time how long it takes to fully extend the cylinder. Also what valve are you using? Your turn.
Replies:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
