Tractor Talk Discussion Board |
Re: Anybody make their own biodiesel?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom in TN on March 26, 2006 at 18:59:52 from (4.153.50.225):
In Reply to: Re: Anybody make their own biodiesel? posted by Glenn F. on March 26, 2006 at 06:48:29:
Glenn, I've actually seen one truck running on used cooking oil. However, there's a whole lot more to the story. The guy collects the oil by hand-pumping it from a nasty barrel at a fast-food place into a big barrel that he hauls around in the back of his pickup. He then takes it home and drains it into a tank where he lets it sit for a couple of days to separate the solids from the oil. He then pumps the relatively clean oil off the top of the tank into another tank that is elevated. He lets it run out of the elevated tank into another tank through a filter that he has in the hose. He then pumps it into a second fuel tank that he has on the back of his pickup. He starts the engine of his pickup with diesel fuel and after the engine gets up to temperature, he switches over to cooking oil. To do that, of course, he has to have the second fuel tank in the back of his pickup, a second fuel line running to the front of the truck, a second fuel filter in the second line, an electrically operated valve that switches from the diesel fuel line to the cooking oil fuel line, and a switch in the cab to operate the valve. About every third or fourth load of oil that he brings home from the local restaurant, he has to scoop out the solid sludge from the settling tank and dispose of it at the landfill. This guy is a "gadget-guy" so it's great for him, but there's no way I'd want to mess around with the whole thing. Good luck, Tom in TN
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|