Tractor Talk Discussion Board |
Re: does anybody know how a hydrogen engine works?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by buickanddeere on February 10, 2006 at 20:37:27 from (216.183.138.123):
In Reply to: Re: does anybody know how a hydrogen engine works? posted by John T on February 10, 2006 at 18:52:35:
It would take a pretty robust hydro service into every hydrogen filling station. Hundreds of new nuclear units would be required to power the system. Even at that, most of the H2 filling would have to be done during electrical "off peak". The fuel cell and electric motor would be the way to go. A small battery bank for brief periods of extra power would be required on the vehicle as well. We store tritium which is a radioactive isotope form of hydrogen at Darlington. The hydrogen is absorbed into a "sponge" inside a low pressure metal vessel. Not unlike storing acetylene in acetone for the oxy acetylene torque sets. As previously stated H2 is a real swine to contain as the little wee molecules pass through just about any material. In my humble opinion running vehicles on grain/ethyl or better yet methyl alcohol would be the answer. Methyl can be made from steam and natural gas mixed in the presence of a catalyst. With abundant steam and hydrogen from nuclear power and reforming “low grade” carbon fuels into clean burning alcohol is a possibility. We could also put up hundreds of thousands of windmills rated at 1.5Mw each.Use nuclear as base load and burn coal on "no wind" days to provide peaking power.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|