Tractor Talk Discussion Board |
Re: Two theories - Electron and Hole
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by txgrn on February 14, 2006 at 08:16:01 from (209.151.112.75):
In Reply to: Two theories - Electron and Hole posted by jdemaris on February 13, 2006 at 05:37:59:
Hi again jd. As a tech and engineer I found that as a tech, troubleshooting was easier chasing the electron. As a designer, I found that it was easier sourcing holes from the + terminal of the power supply and delivering them where needed. So I use both; just tell me which one you want to talk about when conversing. Grin. On engines, there is reasoning at the ignition points and spark plug terminals for which way the molecules are a running. Don't remember which way was the least damaging to the parts.....i.e. + or - grounded electrical system. Mark
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|