|
Tractor Talk Discussion Board |
Re: Ford Hydraulic Loader off Ford 8N w/ pump and
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hobo,NC on February 20, 2006 at 17:39:47 from (166.102.93.11):
In Reply to: Ford Hydraulic Loader off Ford 8N w/ pump and valv posted by Wayne Taylor on February 20, 2006 at 06:29:02:
I do know the Wagner step threw loader will fit a Naa (53-54). A Naa izz about 5” longer than a N and the Wagner loader has the holes drilled in the rear to fit the NAA. I am not sure ‘bout the other types but would think with a little werk it could be made to fit. Also not sure if the pump drive shaft would be a direct replacement but the parts are available to run the pump off the NAA crank pulley.
Replies:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
