Tractor Talk Discussion Board |
Re: turbocharging a john deere 70 diesel
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jon Hagen on March 01, 2006 at 11:28:12 from (69.26.17.107):
In Reply to: turbocharging a john deere 70 diesel posted by Tom in ca on February 28, 2006 at 18:02:14:
OOOOOH,I don't even want to think about putting a bunch of turbo boost pressure in one of those old 2 cyl trip hammers. It reminds me of my uncles old 80 diesel. It broke a rod at about mid point on the rod. The rod half still attached to the crankshaft came up right under the little pony engine,punched its guts and lifted it right of the top of the crankcase. Once the broken rod finished with the pony engine,it turned around and punched through the rear of the crankcase and jammed itself into the transmission which locked up all the trans gears. The poor old locked up thing had to be skidded onto the salvage yard ramp truck,then skidded off into the yards disassembly shed. I had never seen such instant total distruction before,but the guy at the salvage yard said broken rods were fairly common in the old 2 cyl diesels.
Replies:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|