|
Tractor Talk Discussion Board |
Re: NAA transmission question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by souNdguy on April 06, 2006 at 06:29:53 from (12.65.54.39):
In Reply to: Re: NAA transmission question posted by Dudley Do on April 06, 2006 at 06:04:20:
No.. it wouldn't fit unless you were a machinist .. that is.. the massive amount of re-fitting it would require to adapt a 3spd 9n tranny to that tractor may cost more thant he tractor... remember... the 3spt tranny also has the pedistal to the steering column, and dash supports.. N have the rounded hoods and flat head engines.. NAA have the torpedo metal and an OHV engines. Naa sn will be on the angled boss aft of the starter.. or if it is an early 53, on the left front corner of the engine, near the manifold. 9-2-8 N will ahv ethe number on a 1x4 flat boss just below the head, left side of engine, aft of the oil filter canister.. Take a rag or toothbrush... that flat top tranny will have 1-4 and R imprinted into it. ( 9N tranny is dome topped.. not flat like an 8n / naa.. ) Soundguy
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
