Tractor Talk Discussion Board |
Re: rear blade.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Weav on April 11, 2006 at 06:18:48 from (172.136.215.121):
In Reply to: rear blade. posted by Tim Shultz on April 10, 2006 at 18:47:43:
Could do a lot of damage. I just bought another blade at an auction for 35 bucks because it was damaged. It was a heavy duty one, probally near 200 lbs or more. They must have had it backwards and hit a stump or something that sure didn"t move. It drove the blade and pivot box up into the frame of the blade just past the three point linkage. It was a heavy enclosed triangle frame 3/8" thick. After heat and taking all the bolts out we chained it to another tractor and truck to get it straightened out. Point is Tons of damage due to someone abusing equipment.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|