|
Tractor Talk Discussion Board |
Re: 12 volt conv.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on April 11, 2006 at 18:16:56 from (66.244.90.5):
In Reply to: 12 volt conv. posted by DAVE DAHL on April 11, 2006 at 17:35:53:
Dave, That lil side No 1 terminal is the alternators Excite terminal and what I do is run a wire from the ignition switches IGN output (same place that feeds voltage to the coil when ignition switched ON) terminal with a series 10 ohm 5 watt current limiting resistor to the alternators No 1 terminal to serve as the excitation voltage. In the rare event the tractor continued to run despite the ignition being turned off (alternator backfeeding ignition coil), then I add a 5 amp 50PIV diode wired with its - cathode to the alternator. Post back any question n let us know. John T
Replies:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
