Tractor Talk Discussion Board |
Re: 6.5 GM Diesel
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by zbberryz on April 12, 2006 at 16:16:25 from (152.163.100.74):
In Reply to: 6.5 GM Diesel posted by bm3501466 on April 12, 2006 at 15:20:22:
you can get a heat sink or alternative mount off ebay, several different types, the new pmd should come with a # 5 resistor which is most common, but if you do need to get it off, i used a small torx bit end out of a multi type screwdriver, and loosened the inital tightness with a 1/4 end wrench on the torx bit then used my finger to loosen the bit and screw up the rest. if you need to get the resistor out use 2 small drill bits in the little holes on both sides of the resistor and work it up slowly with the bits at the same time.
Replies:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|