Tractor Talk Discussion Board |
Re: How do I plow a hillside REVISED
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CharlieT on April 13, 2006 at 08:17:10 from (157.225.178.190):
In Reply to: Re: How do I plow a hillside REVISED posted by mjbrown on April 13, 2006 at 08:09:25:
I do have extenders on the plows, but on the slope it stills wants to fall back into the furrow. I was wondering if plowing perpendicular to the slope (east to west & west to east) would make a different and keep the sod from falling backinto the furrow. I have never tried this since I am not sure my JD730 can pull the plows up the slope on the west to east run. Also I always thought that you never plow with the slope to minimize water runoff.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|