Tractor Talk Discussion Board |
Re: Leyland 384 tractor clucth removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ron,ar on April 18, 2006 at 19:17:47 from (162.40.137.101):
In Reply to: Leyland 384 tractor clucth removal posted by Shorty007 on April 18, 2006 at 01:14:59:
Hey shorty, I have done a couple of these, the main thing you want to remember is that there is a type of coupeling on these that connects the front main shaft to the rear main shaft. Most of the time you can remove this clamping thing by removing the shifter cover. Don't try to split this tractor without doing this. I had to rebuild one imput shaft that had been damaged by forcing the shaft out of the clutch. Check back, I will see if I can scan an exploded view of how it is made. There is a snap ring keeping the shaft from just sliding out of the clutch. And yes you can get to both clucthes at the same time. As a mater of fact I think the clutch for the pto is the same size and spline as an old six cyl chevy (don't ask) :^)
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|