Tractor Talk Discussion Board |
another tie rod question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Michael G Burns on April 19, 2006 at 15:53:18 from (72.228.23.150):
I have to tell you I'm very grateful I've found this forum! Just bought an Int'l 584, posted a question right away and got great answers. Since then I've been reading the archives and I've learned a lot about safety, etc., and I'm glad! Haven't been around tractors much since I was a kid (that's quite a while ago) and I know just enough to get me in trouble. Anyway, here's the question: The front end seems to wobble and jump a lot on this 584. Put it up on the loader and front wheels seem to have a couple inches play at least. Tie rod ends don't look too bad, but I wonder if I should replace to be safe? Also noticed that the big bolt going through the hole in the square part of the axle (Sorry, I don't know the right names for things yet) appears to allow wiggle---should I tighten these up? Thanks again.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|