Tractor Talk Discussion Board |
Re: Drilling holes in ground to set posts for barn
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by neblinc on April 21, 2006 at 11:39:42 from (24.123.122.114):
In Reply to: Drilling holes in ground to set posts for barn posted by CB in central NY on April 21, 2006 at 10:22:03:
You should be able to rent a skid loader, and depending on the rental place you may be able to get it on Saturday and pay the 1 day rate and bring it back Monday morning. My pole barn that will be started next month, but not built by me. The crew will be using crushed limestone in the holes packing it as they fill the hole. Very solid and no chance of water sitting in the hole to rot the post over a few years. Randy
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|