Tractor Talk Discussion Board |
Re: Drilling holes in ground to set posts for barn
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RayP(MI) on April 21, 2006 at 18:45:30 from (207.241.138.131):
In Reply to: Drilling holes in ground to set posts for barn posted by CB in central NY on April 21, 2006 at 10:22:03:
Whatever you do DON"T try one of those self powered hand held "two man" post hole diggers. They"re really 4 man units in disguise. Don"t ask how I know. Seems as though my pto hole digger will get awfully close to 4" deep, and I have down pressure available, never needed to use it. My auger has a screw thread nose like a wood screw, and as long as the cutter edges are fairly sharp, and not clogged with grass and roots, it"ll dig right in. Be sure to bring the auger up to empty the dirt load two or three times per hole.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|