Tractor Talk Discussion Board |
Re: will removing muffler help????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on April 24, 2006 at 15:04:37 from (64.21.249.40):
In Reply to: Re: will removing muffler help???? posted by Tx Jim on April 24, 2006 at 09:42:45:
I DIDN'T say hot oil in the tranny costs you mileage!!!!! I said fuel is WASTED heating up the oil in an automatic transmission to the degree that it must be continuously cooled. Why would you need a stand-alone tranny controller? Well, the your truck has ONE PCM (powertrain control module) computer to control BOTH the electronic IP AND the tranny, which will have a fit, and go into limp-home mode, if it isn't seeing and controlling the electronic IP, with it's associated sensors. AFAIK, folks who have made the change to mech IP have wound up using a stand-alone tranny controller to make it work. If you are insistant on butchering your truck, here's a guy (Bobby Martin) "in the know" as to how to do it: Go to ebay and look up item #8057084984. He says he can set you up with a "cheap & easy to install transmission computer". Incidently, the guy pushing the book, in his own words, says you won't LOOSE over 1/2 MPG going from the electronic to the mech IP. Good Luck!
Replies:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|