Tractor Talk Discussion Board |
Re: O/T: Removing Wooden Fence Posts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul in Mich on April 25, 2006 at 06:57:23 from (152.163.100.74):
In Reply to: Re: O/T: Removing Wooden Fence Posts posted by Nebraska Cowman on April 24, 2006 at 13:33:46:
Cowman, I"ve done it the hard way myself. I remember my Grandfather giving me the job of taking out an old fence row which had wooden posts every 15 ft or so for 1/4 mile. (Thats a short piece in Nebraska, but a normal field length here in Mich) The first couple of posts, I dug around the edges with a shovel, and realized that I"d probably pass 2 grades in school by the time I finished so I figured I had to come up with somenting, so I walked back to the barn, and found a couple of pieces of 1/2 x2" iron bar stock in the scrap pile. I took one and cut it about 4 ft and the other ended up about 7" I drilled a hole 1"back on the 7 footer and 1" from the end of the 4 footer. Then I found a 6x6" block and chiseled a hole for the 4" iron post to sit in. I carried the contraption along with a chain back to the fence row in a wheel borrow and after I figured out how to prop up the lever system while I wrapped the chain around the post, I was in business. It was about as primative as any contraption could be, but it worked, and when my Grandfather commented on the fact that I would do just about anything to get out of hard work, I asked him why he didnt suggest something easier in the first place. He answered that he could have, but he wanted to see if I would find an easier way, which I did. Mind you it still wasnt easy, just easier. It wan"t a year later that my Dad bought a Ford 8N and with the Ferguson system, the job would have been a piece of cake.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|