Tractor Talk Discussion Board |
Re: rebuilding edge of mower blades with weld
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jeffcat on April 26, 2006 at 12:14:09 from (216.107.36.172):
In Reply to: rebuilding edge of mower blades with weld posted by ironhoarder on April 26, 2006 at 07:48:32:
A little off the mark but very close. About 1983 I made a set of "Hard" blades for my Dad's John Deere 110. Bought that blue color rod from the local weld supply. Comes in a pack of maybe 10 rods and it is VERY hard after it cools. I ground the edge square and matched both blades with a mechanic ruller and by weight on a blade balance. Do like you did with several layers till you get a nice layer on the edge. Found the stuff is so hard that the 4 1/2 inch grinder will not make sparks! What a pain-but what an edge! It will stay razor sharp for several mowings and your grass looks real good. If you hit a stone "driveway stuff" you will make a chip in the edge. Just reweld when you finally get around to it. With "brush hog" type units you must be very careful as how you balance them. I did some very careful measures and ground them to the same dimensions. Weigh them with a balance you can make. Piece of 2x4 with the blade on the end and a fulcrum. Use the other blade as the weight. If you can change them side to side you got it. Keep it simple stupid-KISS and it is no sweat. I was very happy with those blades but boy do they take a lot of work!. Have fun. Jeffcat PS You can get a lot of new blades from Tractor supply Etc. Might be cheeper?
Replies:
Home
| Forums
Today's Featured Article -
A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|