Tractor Talk Discussion Board |
Re: Hey Diesel Mechanics!!!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Eric Rylander on April 28, 2006 at 16:52:11 from (68.51.158.73):
In Reply to: Hey Diesel Mechanics!!!! posted by Keith-OR on April 27, 2006 at 22:02:47:
Yes, many marine engines especially older marine diesels (and gas) had one engine standard (ccw as viewed from the flywheel) and one clockwise, or reverse, rotation. The marine reduction/reverse gears used could not handle full torque output in reverse, or had a different ratio in reverse, and twin screw boats use counter rotating propellers. Otherwise the torque of two props turning the same direction will cause the boat to list over to the side as it runs. However in the 21 years I have been working on marine diesels 99.9% of them are both standard rotation (in a twin application) and one transmission is run in "reverse" and one "forward" but you"d not know from the control levers at the helm as the levers go "forward", the switch is made on the bottom end. I know Detroit used their own Allison marine gears and they (I think) could not be run one forward and one reverse, hence the one left hand and one right hand engine. Gasoline inboards that used Borg Warner "velvet drive" marine gears could not take full power in reverse or something like that- I have no real experience with those gears- but I have done tuneups on many american V8 marinized gas engines and when you ordered a distributor cap it was marked with the cylinder numbers for standard and reverse rotation. I know the large 3500 series Cats can be ordered in reverse rotation. I hope my gibbersih has not confused too many people.:)
Replies:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|