Tractor Talk Discussion Board |
Re: Welding rims and how and can it be done
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Errin OH on May 02, 2006 at 06:35:54 from (198.57.19.126):
In Reply to: Welding rims and how and can it be done posted by old on May 01, 2006 at 21:13:00:
I combine the two sugestions below with slight modifications. First, you didn't say but, if there is a disk (hole mounts in the rim) I wouldn't cut it. Just cut the where the tire mounts. If needed cut the disk away from the part being removed from the good rim. Next I lay out a template (plywood with blocks to fit the rim in it). Mark on it where the cuts need to be. Transfer those marks to both rims (donor and one to be fixed). Doesn't half to be exacly half, just make sure you get a good piece with both sides / sizes. Put square on mark and transfer mark to other side of rim. If you have access to one of those cheap laser lines it makes marking the inside easy, otherwise make a line as best you can between the two marks. Over cut by about 1/4, 1/2, inch and grid down to the line. Once you get close put the pieces back in the jig and finish fitting. After you have a good dry fit in the jig, while in the jig, tack three or spots. Turn it over in the jig and tack it again. Pick it up role it around and when your happy with it finish weld both cuts and center disk if needed. Sounds like a lot of work but it goes fairly quick. Just make sure you have good metal where you weld them back together. I did a ford rim once that looked good but every time I hit it with the welder in blow out another thin spot. Ended up tossing the whole mess after couple hours of screwing with it.
Replies:
Home
| Forums
Today's Featured Article -
Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|