Tractor Talk Discussion Board |
Re: M spinning on plowed sod.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RodInNS on May 05, 2006 at 11:42:07 from (142.177.93.84):
In Reply to: Re: M spinning on plowed sod. posted by Mike M on May 05, 2006 at 06:54:39:
I made your point with regard to hard slick surfaces, namely ice. In field conditions, particulairly in loose soil, you want all the tire you can get, and then double them up. I wouldn't argue that there does need to be a certain ground pressure to get a bit. It does depend somewhat on the surface type. However in general terms the more rubber on the road, the more you're going to pull. You just need to add the appropriate amount of weight to get the pull. Look at drag racers. They don't have narrow tires. Look at nearly any tractor coming off the line today; espectially the Euro tractors. They've all got massive low profile radials. It's all about area, and the more the better. I'm sure if you looked toward the Nebraska test data, there would be a mountain of evidence to support that too. Rod
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|