Tractor Talk Discussion Board |
Wiring help, fuel guage MF1105
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KYfarm on May 10, 2006 at 17:06:28 from (74.130.68.207):
Get this, I'm trying to get my fuel guage to work so I (upon the advise from this forum) started tracing the wires from the back of the guage to their destinations to look for bad connections or broken wires etc... What I found is a wire from one of the two posts going directly to the sending unit on top of the fuel tank. That makes sense, the other post (from the back of the guage)doesn't, it had two wires connected to it, one connected to a wire that terminated at the rear yellow light on the left side and the other wire went straght to the ether button! I'm thinking that this just can't be correct. Can anybody look at their 1105 or know of a wiring diagram for the fuel guage and tell me what is the proper wiring for the posts off of the back of the fuel guage on a massey 1105. Any and all help would be greatly appreciated.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|