Tractor Talk Discussion Board |
Re: Preserving wood on a flatbed trailer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEB on May 17, 2006 at 19:33:04 from (207.94.27.5):
In Reply to: Preserving wood on a flatbed trailer posted by Markiee on May 17, 2006 at 09:46:55:
Couple of comments. First, as was alluded to below, I'd be really, really concerned about an oil treated deck being slippery when its wet. Plus, seems like it would act like the old creosote treated poles & get black stuff all over everything that touched it. Pressure treated lumber is probably the best. Painted would OK if you could make sure it had a non-slip finish. Personally, I prefer Thompson's water seal for outdoor wood. As far as the EPA and other government agencies, I agree that sometimes it seems they're a bunch of desk jockeys that go totally overboard. However, in the case of used oil, I would tend to agree with the regs. Yes, a gallon here or there isn't likely to hurt anything, but you never know for sure. Plus, if you dump a few gallons a year, and your neighbors all dump a few gallons a year, pretty soon you've got the makings of a problem. Like smog from autos, each one makes only a trivial impact, but with a bunch together there's a significant impact. Most places that sell oil will take used oil for free. I've got a couple of old metal jerry cans I collect it in, & when they get full I just take them the next time I need to go to the auto parts store. I'd prefer to burn it & recover some of the initial cost as heat for my shop, but so far I don't think its financially justified. Keith
Replies:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|