Tractor Talk Discussion Board |
Re: Oil required for AC D10
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hurst on May 23, 2006 at 16:17:39 from (66.129.5.5):
In Reply to: Oil required for AC D10 posted by Mutt on May 23, 2006 at 13:44:11:
That is not correct at all. I would check the oil for antifreeze. It sounds like you may have a bad freeze plug. Check the cooling system and see if it is really low. I doubt you would have pulled the wrong plug, the engine oil plug is pretty far away from the rest of the plugs, but I guess it can happen sometimes. If your D10 has hydraulics, which I think are driven off of the distributor drive, that pump could have a bad seal in it, but if you just drained it after sitting, probably a freeze plug. Not sure where they are in that tractor, but generally there is one on the top of the head, back of the head and one or two on the block. Good luck and hope you get it figured out. Hurst
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|