Tractor Talk Discussion Board |
Re: OT small block 3/4 ton
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by charlie2pop on June 03, 2006 at 21:05:05 from (209.33.5.65):
In Reply to: OT small block 3/4 ton posted by Ohio Mike on June 03, 2006 at 18:58:53:
WHO....... Thats way to much load plus trailer for your little truck not just a little bit but 2 times to much my F700 FORD 2 ton truck and trailer and 4 tons of iron weights 21180 pounds i have a gross weight GVW is 24500 this will give you some ideal how much your over my advise get a biger truck or haul it in 2 or more trips been there done that NEVER AGAIN my 2 cents for what it cost ya charlie2pop
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|