Tractor Talk Discussion Board |
Re: Farmall H engine seized
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dan S (NY) on June 05, 2006 at 09:23:06 from (68.113.167.61):
In Reply to: Re: Farmall H engine seized posted by danimal2 on June 04, 2006 at 14:22:32:
I have no direct experience with the H, but I was able to replace my rod bearings on my Ferguson from underneath. My crank was in very nice shape and measured out ok so I just put in new bearings as I was already into the engine to replace a broken piston. If you seized or spun a bearing, I doubt the crank will be in good enough condition to just replace the bearings so it would need to come out to be reground. The only way to tell is to pull the bearing caps and have a look.
Replies:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|